WEBVTT

1
00:00:00.140 --> 00:00:08.140
You should always choose a light that factors in the size of your tent because you don't want to have too little light for your plants.

2
00:00:08.140 --> 00:00:19.140
The best lights have a dimmer, an LM-301B or LM-301H diodes, and you'll also need a timer or timed surge.

3
00:00:19.140 --> 00:00:27.140
Installing the lights is best done with rope clip hangers because you'll have the flexibility to raise or lower your lights.

4
00:00:28.140 --> 00:00:35.140
When you bring the lights closer to your plants, you're able to dim your lights, which in turn saves electric.

5
00:00:35.140 --> 00:00:40.140
For almost all lights, there should be a hole on each corner.

6
00:00:40.140 --> 00:00:50.140
Unfortunately, most lights only come with one or two rope clip hangers, which is absolutely unstable for heavy lights.

7
00:00:50.140 --> 00:00:56.140
I highly recommend purchasing four for any light that is 200 watts or more.

8
00:00:56.140 --> 00:01:05.140
The first thing you want to do is place your light on the floor in the center of your tent in the orientation that you'll be hanging your light.

9
00:01:05.140 --> 00:01:12.140
Factor in where your power line is so that you can have the line exit your tent as efficiently as possible.

10
00:01:12.140 --> 00:01:20.140
Next, grab a rope clip hanger and clip the clip that's attached to the pulley onto each of the four corners.

11
00:01:21.140 --> 00:01:29.140
Now, hold down the tab on each pulley to release as much rope as possible, making sure you don't release all of it.

12
00:01:29.140 --> 00:01:33.140
So when you're using the rope clip hangers, there's two different setups.

13
00:01:33.140 --> 00:01:46.140
You could take these two clips and hang them on this right pole, and then these two clips, and then hang them on this left pole, which is going to be the first setup.

14
00:01:47.140 --> 00:02:01.140
Or the second setup would be these two clips on the back, hanging on that back pole, and then these two clips, one and two, hanging on this front pole up here.

15
00:02:01.140 --> 00:02:08.140
Once each line is long enough, take the clips without the pulleys and push them behind the top pole.

16
00:02:08.140 --> 00:02:13.140
Pull them back down and clip it back onto themselves.

17
00:02:13.140 --> 00:02:21.140
Once all the clips are secured on the top poles, you could raise your lights by pulling each loose rope one at a time.

18
00:02:21.140 --> 00:02:29.140
Be gentle with this and rotate and pull each corner one by one until the light is the level you want.

19
00:02:29.140 --> 00:02:35.140
Now plug in your light and turn it on part two, the floor.

20
00:02:35.140 --> 00:02:48.140
Close the tent and wait at least an hour to determine what the internal temperature of your tent is, and this will determine how you'll be setting up your inline fan and carbon filter.